Dow-Key Microwave MS-1U18S-6-ENET Manuel de l'opérateur télécharger pdf (Page 60)

Remote Operation

7.6 Switch [Module] Command Set

The following contains the switch [module] commands of SCPI that the GPIB /

RS 232 / USB control is compatible with.

7.6.1 :SWITch<id>[:VALue] <number>

Syntax

[ROUTe]:SWITch<id>[:VALue] <number>

Description

This command is used to control the position of the switches. The switch

specified by the numeric suffix <id> is set to position <number>. Switch

positions are specified in a 0 to N fashion, therefore legal values for <number>

are from 0 to the maximum number of position for the switch. For example, a

SP10T switch has 11 positions, 0 thru 10. Position 0 means the switch is set to

its default position.

For most switches the default position is pos 0 (open switch). So in case of a

SP10T switch this means no position is closed.

In case of a transfer switch, since it does not have an open position, the default

position is pos 1. So commanding it to pos 0 will close it to position 1.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 66 67 68

Pas de commentaire

Dow-Key Microwave MS-1U18S-6-ENET Manuel de l'opérateur Page 60